Dakine Circle Mat Stomp

An accessory you install between your bindings on the snowboard, so your back foot does not slip.

This stomp is made from molded urethane. Therefor it is light weight and easy to work with.

For optimum bonding, make sure that both board and stomp are at room temperature, clean all surfaces with rubbing alcohol. When ready - Heat up the the prepared board surface with a hair dryer on the highest setting, along with the adhesive on the stomp. Immediately after heating - Place the stomp and press it down firmly. Stand on it without twisting about - The more weight the better. Allow the bond to cure at room temperature for 24 hours.